Brother BAS-311E - Page 56

Programmer
55
Chapter 2 Programming with Help Function
2. Select with and press .
3. Select
with and press .
4. Input the data number and press
.
5. Press

ESCESC
.
2
Moving to position 4.
1. Select with and press .
2. Press
9
9 9
and press .
The work clamp moves from the start position by each stitch.
3. When the needle point reaches 4, press .
The work clamp stops. If the work clamp passes, input a few
stitches and press . The needle returns for a few stitches of
the input.
4. Press

ESCESC
.
3
Programming a new point.
1. Select with and press .
2. Move the work clamp with
. Press
when the needle point is at 5'.