Programmer
63
Chapter 2 Programming with Help Function
3
Programming a new point
1. Select with and press .
2. Move the work clamp with
so that
the needle point is at 1'.
Record the coordinates (values of X and Y).
3. Press .
1' is programmed.
4. Move the work clamp with to the
opposite position of coordinates recorded
in step 2 so that the needle point is at 1 of
the pattern.
5. Press
.
1 is programmed again.
6. Press
ESCESC
.
4
Deleting 1
1. Select with and press .
2. Press
2
and press .
The work clamp moves to the sewing start position.
3. Press
ESCESC
.
4. Select
with and press .
5. Input the number of stitches to be deleted
and press
.
The example is deleting 1 stitch. Press
1
.
To Next Page
Loading...
