BRUEL & KJAER VIBROPORT 80 - Page 6

Translation of the Original Operating Instructions
VP-80/VP-80 E
7 Operator Interface...........................................................................1-54
7.1 Explanation of symbols ....................................................................1-54
7.2 Structure of the operator interface ...................................................1-55
7.3 Main mask ........................................................................................1-57
7.4 Licensing ..........................................................................................1-58
7.5 Module overview ..............................................................................1-59
7.6 Softkeys ...........................................................................................1-65
7.6.1 General ........................................................................................1-65
7.6.2 Generally valid softkeys ...............................................................1-66
7.6.3 Level 1 / Main mask .....................................................................1-66
7.6.4 Level 2 / Modules .........................................................................1-69
7.6.5 Level 3 / Measurement setup and report mask ............................1-71
7.6.6 Level 4 / Measurements mask .....................................................1-73
7.7 Measuring data analysis - zoom and cursor keys ............................1-76
7.8 Setup settings ..................................................................................1-78
7.8.1 System Setup ...............................................................................1-78
7.8.2 Sensor Setup ...............................................................................1-83
8 Example measurement - Overalls..................................................1-86
8.1 Start of example measurement ........................................................1-89
8.2 Perform new measurement ..............................................................1-89
8.3 Perform predefined measurement ...................................................1-90
8.4 Perform last measurement and check setup ....................................1-91
8.5 Directly start last measurement ........................................................1-92
8.6 Change display / representation during measurement ....................1-93
8.7 End current measurement ................................................................1-94
8.8 Save measurement ..........................................................................1-95
8.9 Load and execute saved measurement (open report) .....................1-97
9 Setup Parameters for the Measuring Modules.............................1-98
9.1 General ............................................................................................1-98
9.2 Important notes on the modules .......................................................1-98
9.2.1 Vibration acceleration and vibration
displacement measur
ements .......................................................1-98
9.2.2 FFT-Analyzer module ...................................................................1-99
9.2.3 Balancer module ..........................................................................1-99
9.2.4 Time Signal module ...................................................................1-100
9.2.5 Tracking .....................................................................................1-100
9.3 Overalls ..........................................................................................1-101
9.4 FFT-Analyzer .................................................................................1-104
9.5 Balancer .........................................................................................1-107