Translation of the Original Operating Instructions
VP-80/VP-80 E
84
Go to the Main Mask.
Select Sensor Setup with the cursor keys.
Press the fire key or the SETUP function key.
Fig. 14 Sensor Setup
All previously acquired sensors are displayed here.
NEW
The NEW softkey adds an additional sensor. A mask opens
for setting the properties. The name of the sensor, the sensor
units (g, mm/s, um, m/s
2
, in/s, mil, V), the sensor sensitivity,
the CCS current and the offset (mV) can be specified.
VIEW
When this softkey is activated, the selected sensor is dis-
played in detail.
EDIT
The EDIT softkey allows you to change the properties of the
selected sensor. The same settings are available as when ad-
ding a sensor.
To Next Page
Loading...
