Mast/Lift system 7000
Main mast 1.6-2.5 t (7100)
Publication No. Date Valid from serial number T-code
261828-040 2008-08-21 6051502 815, 816
© BT Repair Manual RRE140/160/180/200/250 15 – 5
If for any reason it should prove impossible to turn the eccentric
cams (e), proceed as follows:
- Unscrew the adjusting screws (h).
- Plug the adjusting screw hole with a suitable spacer (g). This
should be approximately 35 mm in diameter and approximately
20 mm in length. Now use the adjusting screw as a puller.
IMPORTANT! If there is no spacer, the adjusting screw will drop down
into the eccentric cam once the thread runs out, and it will be impos
-
sible to get it to rethread.
19. Carefully lower the mast to the floor.
20. Place the mast on a pallet on the floor or, for a more comfortable
working height, on a pair of trestles.
DANGER!
Unexpected/uncontrolled movement.
When the mast is laid down, shifting of the centre of gravity may
cause the mast to slide to the floor.
Ensure no one is within the area in which the mast may move: mast
length + 2 metres safety distance. Always stand to the side of the
mast at a safe distance, as far away as the controls of the traverse will
allow.
21. Wipe or wash off any oil spillage on the truck.
ge
To Next Page
Loading...
