btsr SMART KTF 2000 - Page 48

SMART KTF 2000 – KTF/100HP Operation
3A-28 SMART KTF 2000
6) RELAX TENSION = RELAX TENSION
MODE 04
MODE 04MODE 04
MODE 04
Press to enable the parameter programming
VV.V = Value of the RELAX TENSION parameter, i.e. the yarn relaxation
tension.
This function allows to relax the yarn tension to the value set with this parameter,
every time the KTF stops working (see the next function 7) RELAX SPEED). This
function is activated in a way which is tightly related to the selected 8) MODE
function.

MODE 00  the function is active when the KTF stops working with INC-
DEC commands active.

MODE 01  the function is active when the KTF stops working during the
graduation reset phase.

MODE 02/03  the function is active when the KTF stops working.

MODE 04  see paragraph Specific Operation Characteristics for Mode 04
on KTF/100HP Manual, page 3.21.
This function is particularly useful when it is necessary to use a yarn feed operating
tension – 1) MAIN TENSION, different from machine stop tension – 5) EXIT
TENSION, which, in turn, is different from the yarn relaxation tension – 6)
RELAX TENSION.
 For more details and application examples, please refer to KTF/100HP
Operating Manual, Chapter 3.
Press
to move to the next parameter.
7) RELAX SPEED = RELAX SPEED
MODE 04
MODE 04MODE 04
MODE 04
Press
to enable the parameter programming
Yarn feeding speed used to activate the RELAX TENSION function. When the
yarn feeding speed becomes lower then the value set with this parameter, the
RELAX TENSION function, previously described, will be activated.
[Allowed values 01 ÷ 10] where:
01 means activation speed 1 mt/min.
02 means activation speed 5 mt/min.
03 means activation speed 10 mt/min.
.
10 means activation speed 50 mt/min.
This function may be either enabled or disabled (OFF) using the
button.
Press
to move to the next parameter.