SMART KTF 2000 – KTF/RW Operation
3B-26 - SMART KTF 2000
Set the desired value: every how many meters the MAIN TENSION (P1.1) value
must be increased/decreased by the amount specified by METR INC-DEC (P1.5)
parameter.
increases the value by 1
decreases the value by 1
+ increases the value by 1000
+ decreases the value by 1000
After having set the desired value, press
to continue
1.6) METR TARGET (Available on SMART KTF-2000 only)
Press to enable the parameter programming
OFF=Function disabled; to enable it press and hold down
for 3 seconds
Set the desired target (meters)
increases the value by 1
decreases the value by 1
+ increases the value by 1000
+ decreases the value by 1
2.1) EXIT TENSION = P2.1
Press
to enable the parameter programming
VV.V = Value of P2.1 EXIT TENSION parameter, i.e. the tension value of the
device when the machine is stationary or out of the yarn working zone
with INC/DEC de-activated. If you set a value greater than or lower than
the value set with MAIN TENSION parameter you may control the
deceleration phase of KTF device. This parameter can be enabled (setting
a value ranging from 0.2 to 100 g) or disabled (OFF) using the
CONTROL button.
To Next Page
Loading...
