SMART KTF 2000 – KTF/RW Operation
3B-28 - SMART KTF 2000
2.4) K REACT= P2.4
Press
to enable the parameter programming
This parameter represent a multiplier that affects the control algorithm depending
on the yarn elasticity characteristics .
[allowed values 1 ÷ 5] [1= Rigid Yarn.......5= Elastic yarn]
For more details and application examples, please refer to KTF/RW
Operating Manual.
Choose the desired value using:
After having set the desired value, press
to continue.
3.2) MODE= P3.2
Press
to enable the parameter programming
nn = Value of MODE parameter that defines the possible working modes of
KTF/RW devices as for as the INC/DEC programmable commands and “Tension
Error” Alarm Reset are concerned. Allowed values 00, 01, 02 and 03.
For a detailed description of the KTF/RW device working modes, please refer
to:” Characteristics of the various working mode (Mode 00-03) on page 3.14,
of KTF/RW Operating Manual.
Choose the desired value using:
Then press
to continue.
To Next Page
Loading...
