Buchi E-800 - Preparing the Economic Continuous Extraction Chamber (Without Chamber Heater)

5 | Installation BÜCHI Labortechnik AG
30/88 Operation Manual UniversalExtractor E-800
u Attach the condenser rack to the instrument
with screws.
u Prepare the condenser. See Chapter5.17
"Preparing the condenser", page40
u Attach the chamber rack to the instrument with
screws.
u Attach the beaker rack to the instrument with
screws.
u Prepare the Economic Continuous Extraction
chamber. See Chapter5.9.1 "Preparing the
Economic Continuous Extraction chamber
(without chamber heater)", page30
u Select the Economic Continuous Extraction
method on the interface. See Chapter5.19
"Selecting a configuration", page44
5.9.1 Preparing the Economic Continuous Extraction chamber (without chamber
heater)
u Pull the chamber rack.
u Put the extraction glass chamber in the instru-
ment.