BÜCHI Labortechnik AG Table of contents
Operation Manual UniversalExtractor E-800 iii
Table of contents
1 About this document...........................................................................................................7
1.1 Warning notices in this document........................................................................................................ 7
1.2 Symbols............................................................................................................................................... 7
1.2.1 Warning symbols .....................................................................................................................7
1.2.2 Mark-ups and symbols.............................................................................................................8
1.3 Trademarks.......................................................................................................................................... 8
2 Safety....................................................................................................................................9
2.1 Proper use ........................................................................................................................................... 9
2.2 Use other than intended ...................................................................................................................... 9
2.3 Staff qualification ................................................................................................................................. 9
2.4 Location of warning signs on the product .......................................................................................... 10
2.5 Protection devices ............................................................................................................................. 11
2.6 Residual risks .................................................................................................................................... 11
2.6.1 Hot surfaces...........................................................................................................................11
2.6.2 Empty beakers on heating plates........................................................................................... 11
2.6.3 Mechanical damages.............................................................................................................11
2.6.4 Glass breakage......................................................................................................................12
2.6.5 Glass damages during extraction process.............................................................................12
2.6.6 Overfilled extraction beakers .................................................................................................12
2.7 Personal protective equipment .......................................................................................................... 12
2.8 Modifications...................................................................................................................................... 12
3 Product description...........................................................................................................13
3.1 Description of function ....................................................................................................................... 13
3.1.1 Economic Continuous Extraction (without chamber heater).................................................. 13
3.1.2 Soxhlet Extraction (with and without chamber heater)........................................................... 14
3.1.3 Continuous Extraction (with and without chamber heater) ....................................................14
3.1.4 Hot Extraction (with chamber heater) ....................................................................................15
3.1.5 Soxhlet Warm Extraction (with chamber heater) ...................................................................15
3.1.6 Twisselmann Extraction (with chamber heater).....................................................................16
3.1.7 Description of the analyte protection...................................................................................... 16
3.2 Configuration ..................................................................................................................................... 17
3.2.1 Front view (with chamber heater) ..........................................................................................17
3.2.2 Front View (without chamber heater).....................................................................................18
3.2.3 Rear view ...............................................................................................................................19
3.2.4 Upper connections on the rear side....................................................................................... 19
3.2.5 Lower connections on the rear side....................................................................................... 20
3.3 Type plate.......................................................................................................................................... 20
3.4 Scope of delivery ............................................................................................................................... 21
3.5 Technical data ................................................................................................................................... 21
3.5.1 UniversalExtractor E-800 .......................................................................................................21
3.5.2 Ambient conditions.................................................................................................................21
3.5.3 Materials ................................................................................................................................22
4 Transport and storage ......................................................................................................23
4.1 Transport ........................................................................................................................................... 23
4.2 Storage .............................................................................................................................................. 23
4.3 Lifting the instrument ......................................................................................................................... 23
To Next Page
Loading...