Buchi E-800 - 7 Performing an Extraction; Preparing the Instrument for an Extraction; Putting the Glass Sample Tube with Frit in the Extraction Glass Chamber; Adjusting the Optical Sensor (Twisselmann and Continuous Extraction Only)

To Next Page

To Previous Page

7 | Performing an extraction BÜCHI Labortechnik AG

62/88 Operation Manual UniversalExtractor E-800

7 Performing an extraction

7.1 Preparing the instrument for an extraction

Precondition:

R All commissioning operations have been completed. See Chapter5 "Installation",

page25

R Make sure that the tank bottle is empty.

R Make sure that no defective sealings or glass parts are used.

u Switch the On/Off master switch to On.

ð The instrument is starting up.

7.1.1 Putting the glass sample tube with frit in the extraction glass chamber

NOTE

Instead of glass sample tube with frit it is possible to insert a thimble.

u Put the holder for the glass sample tube with

frit into the extraction chamber.

u Put the glass sample tube with frit into the

holder in the extraction chamber.

7.1.2 Adjusting the optical sensor (Twisselmann and Continuous Extraction only)

u Adjusting the optical sensor on the extraction

glass chamber universal.

 White line below the sample.

Sample