Buchi E-800 - Page 4

Table of contents BÜCHI Labortechnik AG
iv Operation Manual UniversalExtractor E-800
5 Installation..........................................................................................................................25
5.1 Before installation .............................................................................................................................. 25
5.2 Installation site................................................................................................................................... 25
5.3 Establishing electrical connections.................................................................................................... 25
5.4 Securing against earthquakes ........................................................................................................... 26
5.5 Connecting the coolant hose ............................................................................................................. 26
5.6 Connecting the solvent tubes to the condenser tank bottle............................................................... 27
5.7 Connecting the coolant tubes to the condenser tank bottle............................................................... 28
5.8 Connecting inert gas (option)............................................................................................................. 28
5.8.1 Connecting inert gas to the instrument (option)..................................................................... 28
5.8.2 Connecting inert gas to the extraction glas chamber (option)................................................ 28
5.9 Preparing the Economic Continuous Extraction (without chamber heater) ....................................... 29
5.9.1 Preparing the Economic Continuous Extraction chamber (without chamber heater) ............30
5.10 Preparing the Soxhlet Extraction (with and without chamber heater)................................................ 31
5.10.1 Preparing the chamber for a Soxhlet Extraction ....................................................................32
5.11 Preparing the Continuous Extraction (with and without chamber heater).......................................... 34
5.12 Preparing the Hot Extraction (with chamber heater).......................................................................... 35
5.13 Preparing the Soxhlet warm Extraction (with chamber heater) ......................................................... 36
5.14 Preparing the Twisselmann Extraction (with chamber heater) .......................................................... 37
5.15 Preparing the extraction glass chamber universal............................................................................. 38
5.16 Installing the protection shields.......................................................................................................... 39
5.16.1 Installing two protection shields (Extraction glass chamber Universal only)..........................39
5.16.2 Installing one protection shield (Extraction glass chamber ECE only)...................................40
5.17 Preparing the condenser ................................................................................................................... 40
5.18 Preparing the tank bottle.................................................................................................................... 42
5.19 Selecting a configuration ................................................................................................................... 44
5.20 Disassembling the condenser circuit ................................................................................................. 44