Burkert ME43 - Page 52

52
Other setting options
Type ME43
BürkertCommunicator:IndustrialCommunicationcongurationarea
Detailedview Setting
Parameter Select Protocol
For a description see chapter “Setting up the büS network”.
Protocolsettings
for PROFIBUS DPV1
Set PROFIBUSaddress.
Setbaudrate Change baud rate.
Advanced
settings
Set Internalcycletime.
Set Controlmodesettings.
Protocolrmwareupdate
Protocolsettings
for EtherCAT
Specify Assistant for checking input and start conditions for büS
communication.
Set StationAlias.
MACaddress is displayed.
Advanced
settings
Set Internalcycletime.
Set Controlmodesettings.
Protocolrmwareupdate
Protocolsettings
for PROFINET
Specify Assistant for checking input and start conditions for büS
communication.
Set DNScompatiblename.
Set StaticIPaddress.
Set Networkmask.
Set Defaultgateway.
Specify TemporaryIPaddress.
MACaddress is displayed.
Advanced
settings
Set Alarmsettings whether or when an alarm is
output (may be overwritten by the controller).
Set Internalcycletime.
Set Controlmodesettings.
Protocolrmwareupdate
Protocolsettings
for EtherNet IP
Specify Assistant for checking input and start conditions for büS
communication.
IPsettings Set BOOTP or DHCP.
Set StaticIPaddress.
Set Networkmask.
Set Defaultgateway.
Specify TemporaryIPaddress.
MACaddress is displayed.
Advanced
settings
Set Internalcycletime.
Set Controlmodesettings.
Protocolrmwareupdate
Table 11: Setting options in Bürkert Communicator, Industrial Communication conguration area – parameter
detailed view – view 1
english