Burkert ME43 - Error Code Descriptions

60
Troubleshooting
Type ME43
14.1 Description of the error codes
Errorcode Description
1/3 Overload detected.
2/1 Overvoltage detected.
2/2 Undervoltage detected.
2/3 Voltage is above the warning limit.
2/4 Voltage is below the warning limit.
2/5 Battery voltage is below the warning limit.
2/6 Voltage drop detected.
3/1 Overtemperature detected.
3/2 Undertemperature detected.
3/3 Temperature is above the warning limit.
3/4 Temperature is below the warning limit.
18/4 SD card is defective.
18/7 Transferable memory is available.
18/8 Transferable memory is not accessible.
18/9
Congurationissuccessfullymanagedbyanotherdevice.
18/10 Congurationisn´tsuccessfullymanagedbyanotherdevice.
18/11 Congurationofthedevicecouldnotbeloadedbythecongurationprovider.
18/12 At least 1 device is missing.
18/13 Bürkert Communicator is required.
18/14 Device replacement necessary.
18/15 Replacement can not be performed because there are too many options. Reduce suitable
clients.
18/16 Problems during device replacement.
18/17 Problems during device replacement. At least 1 object could not be written.
18/18 Device replacement failed.
18/19 Device replacement successful.
18/20
Congurationproviderisnotactivebecausenomemorycardisavailable.
18/21 Morethan1congurationproviderisactive!Switchotheotherproviderfunctions.
32/1 The capacity of the internal message memory has been exceeded.
32/130 Initialization of the device.
33/1 Switch to state „operation“.
33/2 Switch to state „diagnostics active“.
33/3 Switch to state „maintenance“.
33/4
Switchtostate„outofspecication“.
33/5 Switch to state „check function“.
33/6 Switch to state „error“.
33/7 Switch to AUTOMATIC operating state.
33/8 Switch to MANUAL operating state.
33/9
Switchtospecialmode:LEDashing.
33/11 Switchtostate„o“.
33/12 Input value simulation for at least 1 value active.
english