D
Using the Built-in Flash
232
FE (flash exposure) lock obtains and locks the appropriate flash
exposure for the desired part of the image.
1
Press the <D> button.
The built-in flash will be raised.
Press the shutter button halfway and
look in the viewfinder to check that
the <
D
> icon is lit.
2
Focus on the subject.
3
Press the <A> button
(
8
)
.
Aim the viewfinder center over the
subject where you want to lock the flash
exposure, then press the <
A
> button.
The flash will fire a preflash and the
required flash output is calculated
and retained in memory.
In the viewfinder, “
FEL
” is displayed
for a moment and <
d
> will light up.
Each time you press the <
A
> button,
a preflash is fired and the required
flash output is calculated and retained
in memory.
4
Take the picture.
Compose the shot and press the
shutter button completely.
The flash is fired, and the picture is
taken.
A FE LockN
If the subject is too far away and beyond the effective range of the flash,
the <
D
> icon will blink. Move closer to the subject and repeat steps 2 to 4.
FE lock is not possible during Live View shooting.
To Next Page
Loading...
