413
3
Custom Function Settings
N
C.Fn I: Exposure
C.Fn I -1 Exposure level increments
0: 1/3-stop
1: 1/2-stop
Sets 1/2-stop increments for the shutter speed, aperture, exposure
compensation, AEB, flash exposure compensation, etc. This is
effective when you prefer to control the exposure in less fine
increments than 1/3-stop increments.
C.Fn I -2 ISO speed setting increments
0: 1/3-stop
You can set the ISO speed manually in 1/3-stop increments.
1: 1-stop
You can set the ISO speed manually in 1-stop increments.
C.Fn I -3 Bracketing auto cancel
0: On
When you set the power switch to <
2
>, the AEB and white
balance bracketing settings will be canceled. AEB will also be
canceled when the flash is ready to fire or if you switch to movie
shooting.
1: Off
The AEB and white balance bracketing settings will not be
canceled even if you set the power switch to <
2
>. (If the flash
is ready to fire or if you switch to movie shooting, AEB will be
canceled temporarily, but the AEB range will be retained.)
When [1: 1/2-stop] is set, the exposure level will be displayed in the
viewfinder and on the LCD panel as shown below.
Even if [1: 1-stop] is set, ISO speed will be automatically set in 1/3-stop
increments when ISO Auto is set.
To Next Page
Loading...
