7
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to
select the Settings/Adj. tab ( ).
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
8
Press the OK button.
The Set./Adj. Menu is displayed.
9
Press ▲ or ▼ to select Take-up Reel, and then press the OK button.
10
Press ▲ or ▼ to select Auto Feed, and then press the OK button.
The roll is now advanced to the Media Take-up Unit.
11
Hold the roll paper by the middle of the leading edge and
align the right edge with the right edge of the paper core of
the Rewind Spool. With the left and right edges of the roll
paper evenly taut, tape the middle to the paper core to fas-
ten it.
12
Making sure the roll paper is not slack, tape the left and
right side of the leading edge to the paper core.
Note
•
When rewinding heavyweight paper, use strong adhesive tape to fasten it. Otherwise, a rewinding prob-
lem may result.
iPF830
Loading the Rewind Spool on the Media Take-up Unit
User's Guide
Handling and Use of Paper Media take-up unit
369
To Next Page
Loading...
