13
Press the ▼ button to make the roll a little slack.
14
On the Right Media Take-up Unit, pull the Rewind Mode
Switch forward to turn it on. Press the ▼ button to rewind
the roll so that it is nearly taut.
Important
•
Rewind the paper so that the paper core makes at least two revolutions. If the paper is not rewound two
full revolutions, repeat steps 13 and 14.
•
Do not manually force the Rewind Spool or paper core to rotate them. This may damage them. To re-
wind or unwind rolls, press ▲ or ▼ on the Media Take-up Unit.
15
You can unwind rolls by holding down ▼ on the Control
Panel.
16
Refer to the following table and securely insert the Weight
Flange and Weight Joint suitable for the type and width of
roll into the Weight Roll.
Loading the Rewind Spool on the Media Take-up Unit
iPF830
User's Guide
Handling and Use of Paper Media take-up unit
370
To Next Page
Loading...
