Important
• If you are not using the Media Take-up Unit when printing long documents such as banners, spread a clean cloth or
paper on the floor. Use the Output Stacker to prevent long printed documents from being soiled by the floor after they
are printed. (See "Using the Output Stacker.") →P.564
Note
• For details on supported sizes and types of rolls, see Paper Sizes or the Paper Reference Guide. (See "Paper Sizes.")
→P.522 (See "Types of Paper.") →P.522
• To wait until the ink dries after printing before cutting the roll, set Drying Time in the printer driver. (See "Specifying the
Ink Drying Time for Rolls.") →P.544
• Once you have used all the paper on a roll, clean the platen. If the Platen inside the Top Cover becomes dirty, it may soil
the underside of paper. (See "Cleaning Inside the Top Cover.") →P.861
1
Turn the printer on. (See "Turning the Printer On and
Off.")
→P.21
2
Load the roll on the Roll Holder. (See "Attaching the Roll
Holder to Rolls.") →P.530
iPF9400
Loading and Printing on Rolls
User's Guide
Basic Printing Workflow Printing procedure
23
To Next Page
Loading...
