Canon MultiPASS MP390 - Using the MP Toolbox

Chapter 7 Printing From Your Computer 77
Changing Print Settings With The Print Advisor
Follow this procedure:
Changing Print Settings Manually
Follow this procedure:
1 Open the document in the application software, and select the command
to print.
This in most cases will be [Print] in the [File] menu or toolbar.
2 In the [Print] dialog box, click [Properties].
3 In the [Properties] dialog box, on the
[Main] tab, click [Print Advisor].
4 Follow the instructions on the screen.
1 Open the document in the application software, and select the command
to print.
This in most cases will be [Print] in the [File] menu or toolbar.
2 In the [Print] dialog box, click [Properties].
3 In the [Properties] dialog box, change the settings on the relevant tab or
screen.
To restore the original settings after changing them, click [Defaults].
4 Confirm, then click [OK] to apply the changes and close the dialog box.
• The changes are applied to the settings, and the dialog box closes.
• To cancel changing the settings and close the dialog box, click [Cancel].