Chapter 10 Sending Faxes 99
X How To Use Directory Dialing
You can dial the number easily when the recipient’s fax/telephone numbers are registered in the
directory.
NOTE
<NO DATA> appears on the LCD if no fax/telephone number is registered in the directory. For details on
registering directory dialing, see page 87.
Dialing The Number Using Directory Dialing
Follow this procedure:
X Redialing A Busy Number
There are two methods of redialing: Manual redialing and Automatic redialing.
Manual Redialing
To manually redial the last dialed number, press [Redial/Pause].
NOTE
• For details on memory sending, see page 98.
• To cancel manual redialing, press [Stop/Reset].
Automatic Redialing
When using memory sending to send a document and the recipient’s line is busy, your machine will
redial the number after a specified interval.
NOTE
• Your machine enables you to customize automatic redialing settings to suit your needs.
• To cancel automatic redialing, wait until the machine starts redialing, then press [Stop/Reset]. Follow the
instructions on the LCD.
• You can also delete the document from memory. For details, see page 100.
Customizing Automatic Redialing Settings
You can customize the following settings:
• Whether or not your machine redials automatically
• The number of times the machine redials (1 to 10 times)
• The time interval between redialings (2 to 99 minutes)
NOTE
For details on the redialing settings, see page 154.
1 Press [Directory].
2 Use [W] or [X] to select the number registered in the directory (01-40).
NOTE
For details on memory sending, see page 98.
To Next Page
Loading...
