Car-O-Liner CTR9 - Page 107

CTR9 Car-O-Liner Group AB
49023, EN - rev. 4, 2020-01 107
Water flow off
- The cooling water flow is not sufficient.
- Make sure that the cooling water pump
is not switched OFF.
Over temperature
- The welder is overheated.
- Wait and try again when “Over tempera-
ture” message disappears.
- Check cooling water level.
Add cooling water if level is low.
Control voltage error
- Missing supply voltage or value below
specified level.
- Contact authorized Car-O-Liner
service personnel.
Fan error
- Fan malfunction.
- Contact authorized Car-O-Liner
service personnel.
System error
- Welder internal error.
- Contact authorized Car-O-Liner
service personnel.