CTR9 Car-O-Liner Group AB
49023, EN - rev. 4, 2020-01 31
3.7 Filling of cooling liquid
Use Car-O-Liner High-Tech Protection Fluid (art no 33944). Mix 3 litres of
concentrate with 17 litres of decalcified water, see water quality information
below (the CTR9 tank has a volume of 20 litres). Freezing point -10°C.
WARNING! Do not fill the water tank with anything but water (and
antifreeze agent, if needed). Improper handling may result in personal injury
and/or damage to the equipment.
IMPORTANT! Do not use water that is salt, brackish or rich in lime.
If there is any uncertainity regarding the quality of the water, use destilled
water.
IMPORTANT! If the heater is used in temperatures below freezing point,
Car-O-Liner´s recommended antifreeze agent must be used. If the machine is
used in temperatures below -10°C, a higher concentration of High-Tech
Protection Fluid must be used.
1. Loosen the lid on the top of the water tank.
2. Fill the water tank with water mixed with antifreeze.
NOTE: Do not fill up the tank entirely to allow space for the hot water to
expand. Maximum/minimum level is marked on the cooling liquid display.
Minimum
level
Maximum
level
To Next Page
Loading...
