Car-O-Liner CTR9 - Weldlogger (in CTR9 Welder and Optional PC Software); Activate Weldlogger

CTR9 Car-O-Liner Group AB
49023, EN - rev. 4, 2020-01 75
6.7 WeldLogger (in CTR9 welder and optional PC software)
6.7.1 Activate WeldLogger
In the "WeldLogger" you can create work orders and all your welding work
is documented in log files. These log files may be printed using the optional
PC software.
1. Open the "WeldLogger" by pressing the "WeldLogger" button
2. Create new log file or continue to work on existing log file
3. Go to section of the vehicle by pressing the "right" button. Select
vehicle section by pressing the "up/down" button (for explanation of
section codes, see section 6.5.2 Vehicle section codes).
4. Activate "WeldLogger" by pressing the "right" button (Start Log).
5. To end "WeldLogger", press "down" button (End Log).