CTR9 Car-O-Liner Group AB
49023, EN - rev. 4, 2020-01 81
6.8 Turning off cooling water when changing electrodes
When you change electrodes you need to turn off the cooling water pump in
order to prevent water from pouring out from the yoke.
1. Press the "Water flow" button to turn OFF the cooling water pump.
2. Red box with "Water flow off" is shown.
3. After changing the electrodes, press the "Water flow" button again
to turn ON cooling water pump before you start welding!
IMPORTANT! It is not possible to start welding before cooling water
pump flow is turned on.
To Next Page
Loading...
