Car-O-Liner CTR9 - Moving the Machine with Support Arm

Car-O-Liner Group AB CTR9
42 49023, EN - rev. 4, 2020-01
3.13.2 Moving the machine with support arm
WARNING! Always use the handle to move the welder. Do not pull the
cable or the tong to move the welder. The welder might tip, causing personal
injuries or serious damage to the welder. When moving the machine, the
C-Tong must be fixed at the intended holder (on the side of the machine)
and must not hang on the support arm. A swinging tong might cause
personal injuries or material damage.