Car-O-Liner Group AB CTR9
84 49023, EN - rev. 4, 2020-01
6.10.1 Installing the multi-function gun
Installing the multi-function gun cable to the C-Tong:
1. Fit the current cable adapter between the electrodes.
2. Follow the polarity shown on the label.
3. Press the trigger button on the C-Tong once. The gun closes,
contacts the adapter and stays closed.
4. Insert and lock the control plug in the socket at the left sideof the C-
Tong.
5. Fit the multifunction gun with the desired tool
.
6. The welding object muste be grounded with the connector.
Figure 6.2 Installing the Multi-function gun
NOTE: The ground connector must be connected to the outer body sheet.
To Next Page
Loading...
