Car-O-Liner CTR9 - Preparing the C-Tong for Welding

Car-O-Liner Group AB CTR9
50 49023, EN - rev. 4, 2020-01
4.5 Preparing the C-Tong for welding operation
When carrying out the operations described in section 4.5, it is recommend-
ed to keep the C-Tong in the C-Tong holder of the welding machine.
4.5.1 Changing the C-Tong electrode yoke
Change the electrode yoke by following the instructions below:
1. Press the "Water flow" button to turn OFF water pump flow.
2. Release the yoke locking lever.
3. Disconnect the two cooling liquid hoses by the
quick-action couplings.