Carrier TRANSICOLD Vector 8500 User Manual

62-11640 3–4
3.4 SWITCHING OPERATING STATE
WARNING
!
Do not connect power plug to any electrical outlet without checking that it meets the 460/3/60
and 30 Amp electrical requirements of the unit.
WARNING
!
Ensure the power plug is clean and dry before connecting to any electrical outlet/receptacle.
Standby Electrical Guidelines
NOTE
The unit is equipped with automatic phase reversal which insures that the electric motors will run in the
correct direction.
For safe, reliable operation in Electric Operation, it is important to consider the following guidelines:
• NEVER connect the unit to a high voltage power source unless the START/RUN − OFF switch is in OFF
position.
• The power supply cable and circuit breaker must comply with local electrical code and unit specifications.
• The power supply cable must be equipped with a ground connection.
• Repairs or maintenance to the supply voltage circuit should only be performed by licensed/authorized per-
sonnel.
OFF
START/RUN
O
I
CONTINUOUS
START/STOP
MENU
ALARM
DEFROST
COOLDIESELSTART/STOP
STATUS OK
36
36
.2
BOX TEMPERATURE F SETPOINT F
If DIESEL is displayed, the unit is in Engine Operation.

Carrier TRANSICOLD Vector 8500 Specifications

General

Brand	Carrier TRANSICOLD
Model	Vector 8500
Category	Automobile Accessories
Language	English