14.4 Bill device
Frontal view of the bill device
1. Validator
2. Recyclers
3. Stacker
The bill device consists of three elements: validator, the recyclers and the stacker.
14.4.1 Bills validator
The validator is responsible for validation of introduced bills no
matter the side or the direction of introducing, and rejection of
counterfeit bills.
Also, it is the exit from where the bills are dispensed.
14.4.2 Combination of the recyclers and the dispenser
Includes two recyclers, each for one denomination, with the capacity
until 100 bills in each recycler.
Includes the security key for opening.
Consult the manual CD3-Manual change of bills recycler
denominations in order to change the denominations in any of the
recyclers.
14.4.3 Stacker
The stacker is the final devices for the bills. Here the bills are
saved until withdrawal.
Includes a key so that no one would have the access to the stored
bills inside the stacker. Also it is possible to add a blockage that
restricts the removal of the stacker and of recyclers module.
Internal view and Devices | 65
To Next Page
Loading...