transmissions do not always work indoors, for example);
and (c) handset signals reaching wireless “base stations”
(atmospheric and environmental conditions may cause
variations in handset receiving signal strength).
Also the transmission of the ALI information is subject,
in part, to system constraints within the wireless network
to which the E911 signal is transmitted and over which
UTStarcom has no control.
Finally, customers are advised that the G’zOne
Boulder™’s ALI capability is to be used for E911
purposes only.
911 in Lock Mode
The “911” call service is available even in the lock mode.
1 . Enter “911” then press the Send Key .
2 . The call connects.
3 . The phone exits the Lock Mode for 5 minutes.
4 . To exit emergency mode, press the End/Power Key
.
911 Using Any Available System
1 . Enter “911” then press the Send Key .
2 . The call connects.
3 . The phone remains in Emergency Mode for 5
minutes.
4 . To exit emergency mode, press the End/Power Key
.
214
To Next Page
Loading...
