24
Configuration with SLOW PULSE
5 3 6241
1. Peak current.
2. “Absolute” basic current value in Ampere (default) or as % of the peak current.
3. Duration of the peak current.
4. Duration of the basic current.
5. HOT START – Increases the welding current, on a percentage basis, for a time interval that can be set at the start of the welding
process, thereby reducing the risk of poor melting at the start of the joint.
6. ARC FORCE - Regulates the dynamic characteristics of the arc, in percentage terms.
NOTE: If the BACK
key is held down for 2 seconds, the parameter goes back to its default setting.
Once the all the selections/settings indicated above have been made, welding can begin.
During the welding process the display shows the current and the real voltage at which the operator is actually welding.
To Next Page
Loading...
