44
Energy saving menu
This function manages correct functioning of the cooling fan and cooling equipment that only run when strictly necessary.
FAN MOTOR
The fan motor is started when:
• The welding phase is in progress or for a certain period of time after this is finished.
• The thermostat intervenes or for a certain period of time after it has just been reset.
COOLING UNIT
With the “ON DEMAND” default setting, the cooling system is activated:
• For a few seconds when the machine switches on. This operation is used to make the cool-
ing liquid circulate through the plant at the correct pressure. Call the technical service de-
partment if, when the cooling system is switched off, the error message does not
disappear from the TFT display.
• While the welding phase is in progress or for a certain period of time after this is finished.
To change the cooling unit operating mode, go to the “CONFIGURATION” menu, and select the “WELDING” menu.
You can access the “CONFIGURATION” menu by:
• Holding down the SET key
for 5 seconds.
• By selecting the icon from the process setting page.
• Select the “WELDING” menu.
CONFIGURATION
GENERAL
WELDING
INFORMATION
ERROR PAGE
PANEL LOCK
MAIN MENU MAIN SUB-MENU
PARAMETERS /
HIGH - LOW LIMIT
DEFAULT
VALUE
NOTE
WELDING COOLING
ON DEMAND X
ON DEMAND cooling on in automatic mode.
During welding or for a certain period of time after
this is finished.
ALWAYS ON Cooling always on
ALWAYS OFF Cooling always off
To Next Page
Loading...
