15
WARNING
Failure to tighten the thermocouple nut could result in microwave
leakage that can cause damage to the microwave furnace system and
be harmful to the operator.
17. Attach the subminiature connector from the thermocouple wiring to the
instrument subminiature plug. The second thermocouple connector is used for
temperature verifi cation, and will remain disconnected at this time.
18. Install the thermocouple access door on the top of the instrument cover.
19. Plug the female end of the power cord into the power cord receptacle on the
power panel in the rear of the instrument. Plug the male end of the power cord
into a grounded, dedicated electrical outlet.
20. Ensure that the voltage selection switch is in the proper position (setting) to
parallel line voltage (208/230V or 220/240V).
21. If applicable, install the printer and/or external balance according to instructions
included in this manual.
22. Position the power switch located on the power panel in the rear of the
instrument in the “on” position.
To Next Page
Loading...
Need help?
General
