To Next Page

To Previous Page

Ramping Method - External Balance (Standard)

1. Press the START key to begin the method.

XXXXXXXX

RAMP XX C

XX:XX:XX Set Point

DWELL XXX C

XX:XX:XX

Status: Paused

2. Press the “Balance” key.

Edit Sample ID

ENTER NEW ID

FINAL WEIGHT

ERASE ID

SELECT ANALYSIS % ASH

Note: If applicable, use the arrow keys to highlight Select Analysis and press the

SELECT key to toggle and select the appropriate type of analysis – % Ash, % LOI,

% Total Volatile, % ROI or % LOD.

3. Using the arrow keys, highlight Enter New ID. Press the SELECT key.

SAMPLE ID: XXXX

0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J

K L M N O P Q R S T U V W X Y Z Á À Â Ä

Å Ç É È Ê Ë Í Ì Î Ï Ñ Ó Ò Ô Ö Ú Ù Û Ü .

SPACE DELETE

4. Using the arrow keys, highlight the ﬁ rst letter or number of the sample identiﬁ -

cation. Press the SELECT key. Continue highlighting the letters/numbers (23

maximum) of the ID and pressing the SELECT key until the proper identiﬁ ca-

tion is displayed on the screen. Note: When entering numbers, the numeric

keys can be used.

5. Press the NEXT key.

Start Weight

SAMPLE ID: XXXX

Clear external balance pan

and press NEXT

6. Ensure that the external balance is clear. Press the NEXT key.

CEM Phoenix User Manual

Questions and Answers: