To Next Page

To Previous Page

Quick Test - External Balance

Quick test permits entry of time and temperature parameters for a one-time ashing

procedure using either the standard or syringe weighing format. Ashing procedures

performed with the Quick Test method cannot be saved in the instrument memory.

To enter and store a method in the instrument directory, refer to the “Edit/Create

Method” section of this manual.

CEM Method Menu

EDIT/CREATE QUICK TEST LOAD

METHOD METHOD

Current Method: XXX

Press START to Begin

1. Using the arrow keys, highlight Quick Test. Press the SELECT key.

Method Setup

DWELL TIME: 00:00

OPERATING TEMP.; XXX

OPTION: Standard

2. Using the arrow keys, highlight Dwell Time. Use the numeric keys to enter

the desired method dwell time. Dwell time can be set from 1 minute to 99 hours

and 99 minutes. (Examples: To enter 5 minutes, press “5;” to enter 1 hour, press

“1, 0, 0.”)

3. Using the arrow keys, highlight Operating Temperature. Use the numeric keys

to enter the desired test temperature.

NOTE

The maximum operating temperature of the standard furnace is

1000 C. The maximum operating temperature of the high tempera-

ture furnace is 1200 C.

Note: If a value greater than 1200°C is entered, the Phoenix will automatically

default to 1200°C.

Note: The maximum operating temperature of the standard furnace is 1000°C, and

the maximum operating temperature of the high temperature furnace is 1200°C.

4. Using the arrow keys, highlight Option. Press the SELECT key to toggle and

select Standard or Syringe.

CEM Phoenix User Manual

Questions and Answers: