Propeller Balancing
Vibrex 2000 and Vibrex 2000 Plus User Guide 69
Enter (or edit) the aircraft ID, as follows:
1. Press the
AIRCRAFT ID
context key, next to the AIRCRAFT ID
label.
The Edit Aircraft ID screen displays (see below).
2. From this screen, select the places to be filled by pressing the
CURSOR LEFT
or
CURSOR RIGHT
context key (see the illustration
under step 1).
NOTE: When the user is printing, the aircraft ID entry for the
current aircraft prints out on the hard copy. This ID also labels data
when the user is reviewing propeller balance measurements.
3. If the user makes a mistake, press the
RESTORE/RESET FIELD
context key to start over.
4. After the user has entered the aircraft ID, press
START (dedicated
key) to return to the first Propeller Balance Setup screen.
5. The user may press
GO BACK to cancel or undo any edits. This
action also returns the user to the previous screen.
5.4.1.2 Selecting Channels
The Vibrex unit defaults to the following channel assignments:
• CHANNEL <1A> for the balance channel located nearest the plane of
the propeller with the notation “PROP CHAN”
• <NONE> for the rear check Velocimeter
CURSOR LEFT
if ok, push START
= EDIT AIRCRAFT ID ==
CURSOR RIGHT
RESTORE/RESET FIELD
[ ]
CURSOR LEFT
if ok, push START
= EDIT AIRCRAFT ID ==
CURSOR RIGHT
RESTORE/RESET FIELD
[ ] ENG-[ 1 ]
CURSOR
ENTER THE
AIRCRAFT ID
NUMBER HERE; THE
DEFAULT IS 1
To Next Page
Loading...
Need help?
General
