88 Chadwick-Helmuth Company, Inc.
Chapter 5 - General Operation
2. Press the context key labeled <prop meas> to view the
<rear meas> reading, if a rear measurement was taken.
3. Press the context key labeled <rear meas> to view the propeller
balance adjustment.
NOTE: The RPM of the balance run displays in the lower left
corner of the balance reading.
4. The user may go directly to another run by pressing the
NEXT RUN
or
PREV RUN
context key.
5. The user may view the correction for the propeller by pressing the
key labeled <adjustment>, displaying a screen giving this
information.
5.4.5.2 Reviewing Other Balance Measurements
Review other balance measurements, as follows:
1. From the
Review Menu screen press the
MEASUREMENTS
context
key. The measurements display, as follows:
• The measurement number displays in the upper right corner of the
screen.
• The annotation displays in the lower right corner of the screen.
• The RPM of the balance measurement displays in the lower left
corner of the screen.
• The RPM of the balance run displays in the lower left corner of the
balance reading.
A day/date code also displays. See Section 5.4.5.1 “Reviewing
Propeller Balance Measurements” on page 87.
2. The user may go directly to another run by pressing the
NEXT RUN
or
PREV RUN
context key.
3. The user may skip to any measurement stored by pressing the
MEASUREMENTS
context key and entering the run number the user
wants to view.
To Next Page
Loading...
Need help?
General
