1 Operational Manual
2.47 Display Menu of Producing Information
F1 F2 F3
F4 F5
F6
F7
F8
F9 F10
PRODUCTION IMFORMATION DATE 1999/10/17 TIME 11:25
MOLD START DATE STOP TIME PRODUCTS DEFECT TOTAL
AAA 10/17 08:00 329 9 135518
AAA 10/16 08:22 10/16 17:10 1028 15 134590
AAA 10/15 08:15 10/15 16:52 905 21 133562
BBB 10/14 13:10 10/14 17:02 928 12 132657
BBB 10/14 08:11 10/14 10:46 356 9 131729
BBB 10/13 08:00 10/13 20:16 1268 38 131373
CCC 10/12 08:20 10/12 11:56 822 52 130105
CCC 10/10 08:12 10/10 17:07 1988 102 129283
CCC 10/09 08:06 10/09 07:02 1978 115 127295
CCC 10/08 13:52 10/08 17:04 818 48 125317
EEE 10/08 08:06 10/08 11:46 392 20 124499
CCC 10/07 08:09 10/07 20:11 2500 68 124107
JJJ 10/06 13:07 10/06 17:08 298 7 121607
JJJ 10/06 09:29 10/06 11:47 205 3 121309
JJJ 10/06 08:16 10/06 09:26 88 1 121104
TTT 10/05 08:08 10/05 20:12 2513 56 121016
TTT 10/04 08:24 10/04 20:02 2488 64 118503
HHH 10/03 11:05 10/03 16:40 523 1 116015
UUU 10/03 08:22 10/03 09:44 221 4 115492
RUNNING TIME ?????HR??MIN
RESET AUTO RUNNING TIME :?????HR??MIN RESET
D
BZ
Menu45
The purpose of this menu is to record CDC-2000 controller’s time and mold records in auto mode, it must
use class “2” or above in order to display. It can record 40 data, and press
or to move
up or down to research records. Descriptions of column are as follows:
A) Mold no.: Record producing mold number.
B) Auto operation: Record the starting time.
C) Stop time: Record the stopping time of producing.
D) Production no.: Record the producing numbers during operation.
E) Defection no.: Record the bad producing numbers.
F) Total no.: Record the total numbers during operation.
G) Operation-time descriptions:
G.a) HHHH: Display
“
hours
”
G.b) MM: Display
“
minutes
”
Reset the operational time: press
when the
“
aa
”
is in red ground color, you
04/08/13
156
To Next Page
Loading...
