Chen Hsong CDC-2000 - Page 21

CDC-2000
操作手冊
Operational Manual
K)
“
FFF
”
:Temperature setting of barrel sector 5.
L)
“
fff
”
:The practical temperature of barrel sector 5.
M)
“
GGG
”
:Temperature setting of barrel sector 6.
N)
“
ggg
”
:The practical temperature of barrel sector 6.
O)
“
HHH
”
:The backup temperature setting.
P)
“
hhh
”
: The practical backup temperature display.
Q)
“
WWWWW
”
:Display the volume of product.
R)
“
XXXXX
”
:Display the volume of good product.
S)
“
MMMM.M
”
:Display the duration of production in auto operation.
T)
“
KKKK.K
”
:Display the residue time of injection in auto operation, and be able
to adjust the time setting value by entering the numerical value.
U)
“
LLLL.L
”
:Display the residue time of cooling in auto operation, and be able
to adjust the time setting value by entering the numerical value.
V)
“
NNNN.N
”
:Display the residues time of recycle operation in auto operation, and
be able to adjust the time setting value by entering the numerical value.
W)
“
OOOO.O
”
:Display the present location of ejector.
X)
“
PPPP.P
”
:Display the present location of clamping.
Y)
“
QQQQ.Q
”
:display the present location of injection.
Z)
“
RRR
”
:display the speed of screw in plasticizing.
AA)
“
SSS
”
:display the hydraulic pressure.
2.4. Cycle Time Monitoring Menu
F1 F2 F3
F4 F5
F6
F7
F8
F9 F10
Chart 62
Cyclic time chart
aaaa.a carriage fff.ff
mold close forward injection
Core-in 1 Core-in Core-in 2
bbbb.b cccc.c dddd.d
gggg.g
Hold pressure
Cycle time: rrrr.r
Total products: sssss
qqqq.q hhh.hh
Middle time plastic delay
pppp.p iiii.i
Distance of ejector plasticizing
llll.l
mold open cooling time
core 1 core in core 2
oooo.o nnnn.n mmm.m
Mold c Ejector Inject Plast. Temp. Product Funct. Time Prompt Cycle
Mold o Screw Setting Count. Selec.SettingSetting Monitor
kkkk.k jjj.jj
04/08/13
17