Chen Hsong CDC-2000 - Page 22

CDC-2000
操作手冊
Operational Manual
The main purpose of the Menu is to exhibit the time monitoring in auto operation.
Move the cursor to the parameter that you want to change, adjust the parameter
by numerical keys, and then push key to finish the correction. The setting
description of
“
Cycle Time Monitoring
“
Menu (62) are shown below:
A) aaaa.a : Display the time of clamping operation.
B) bbbb.b : Display the time of core 1 operation.
C) cccc.c : Display the time of core-in operation.
D) dddd.d : Display the time of core 2 operation.
E) eeee.e : Display the time of clamping forward operation.
F) fff.ff : Display the time of injection.
G) ggg.gg : Display the time of injection and hold pressure.
H) hhh.hh : Display the time of plasticizing delay, which can be adjusted.
I) iiii.i : Display the time of plasticizing.
J) jjj.jj : Display the time of carriage backward, which can be adjusted.
K) kkkk.k : Display the time of cooling, which can be adjusted.
L) llll.l : Display the time of mold opening.
M) mmmm.m : Display the time of core 2 off operation.
N) nnnn.n : Display the time of core-in off operation.
O) oooo.o : Display the time of core 1 off operation.
P) pppp.p : Display the time of ejector operation.
Q) qqqq.q : Display the time of middle time operation, which can be adjusted.
R) rrrr.r : Display the time of productive cycle.
S) sssss : Display the produced volumes.
T) ttttt : Display the good produced volumes.
U) uuuuu : Display the bad produced volumes.
04/08/13
18