Chen Hsong CDC-2000 - Page 24

CDC-2000
操作手冊
Operational Manual
setup.
M) IIIII : Booster cylinder fast mold-closing end-position setup.
N) TTT : Display the mold-closing fore of toggle type machine by moving cursor to
“
FFFFF
”
, then press key.
O) iii.i :Display the mold-closing operational time, the descending order of the
requirement for booster cylinder mold-closing switch position setup is.
RRR.R mm ≧ WWWW.W mm ≧ CCCC.C mm ≧ FFFFF p ≧ IIIII p。
2.5.1.2. Sequence Diagram of Booster Cylinder Mold-Closing.
Mold-closing distomce fast mold-closing low-preesure high-pressure
Mold-closing mold-closing
Counter-balance distance
Mold-closing confirm
Speed setup
Pressure setup
Counter balance Starting Distonce
end-position setup WWWW.W
CCC.C FFFFF I I I I I
ZZZ.
AA
BB
ee
XX
YY
ee
DD
EE
ff
GG
HH
gg
AA
BB
ee
2.5.1.3. Mold-Opening Setup
Move the cursor to the desired parameter for mold-opening, key is your desired
digits and press to complete the correction.
Code descriptions for Menu (03) Booster Cylinder mold-opening are as
below:
A) JJ: Booster cylinder slow mold-opening speed setup.
B) KK : Booster cylinder slow mold-opening pressure setup.
C) SS : Booster cylinder slow mold-opening counter-balance pressure setup.
D) LLLLL : Booster cylinder slow mold-opening end-position setup.
E) MM : Booster cylinder fast mold-opening speed setup.
F) NN : Booster cylinder fast mold-opening pressure setup.
G) TT : Booster cylinder fast mold-opening counter-balance pressure setup.
H) OOO.O : Booster cylinder fast mold-opening end-position setup.
I) PP : Booster cylinder decelerated mold-opening speed setup.
04/08/13
20