CDC-2000
操作手冊
Operational Manual
F) HHHHHH: Feedback options of core-in 1. Press or for selecting one
of two modes listed below and then press
to complete the selection.
Code descriptions are as follows:
F.a) Select
“
timer
”
to confirm the completion of core-in 1.
Time is set at “GGG.G”, and the program timer code is “Tim 12”.
F.b) Select
“
Limit switch
“
as a confirmation of the completion by connecting limit
switch to Input 8, and the set time of
“
GGG.G
”
acts as core-in 1 timer
F.c) Control.
G) II: Setting up core-out 1 for action speed.
H) JJ: Setting up core-out 1 for action pressure.
I) CCCCCCCCC: Core-out 1 action selection. Press
or for selecting one
of four modes listed below and press
to complete the selection.
Code descriptions:
I.a) Core-out 1 off.
I.b) Before mold-opening: Core-out 1 after molds open.
I.c) During mold-opening: Core-out 1 during mold opening at the set position of
“
DDDD.D
”
.
I.d) After mold-opening: Core-out 1 after molds open.
J) DDDD.D: Core-out 1 is executed when mold-opening moves to this position.
K) KKK.K: Time setup for core-out 1.
L) LLLLLL: Feedback options of core-out 1. Press
or for one of two modes
listed below and push to complete the selection.
Code descriptions for function selection are as follows:
L.a) Select
“
Timer
”
to confirm the completion of core-out 1. Time is set at
“
KKK.K
”
,
and the program timer code is
“
Tim 13
”
.
L.b) Select
“
Limit switch
”
as a confirmation of the completion by connecting limit
switch to Input 9. The set time of
“
KKK.K
”
acts as timer control.
2.8.2. Core-pull 2 setup
Move cursor to the parameter of core-pull. Key in desired digits and press to complete
the correction.
Code descriptions for Menu (06) are as follows:
A) QQ: Speed setup for core-in 2.
B) RR: Pressure setup for core-in 2.
C) MMMMMMMMMM: Mode options for core-in 2. Press either or to select
04/08/13
44
To Next Page
Loading...
