6 ChroMate™ Operator’s Manual Doc. 4300 Rev. E
• Install as Directed Install the instrument on a sturdy, level surface capable of
safely supporting the instrument’s weight 12.471 lbs (5.657 kg). The mounting
surface should be free of vibrations. The instrument does not require fastening to
the bench top.
• Provide Proper Ventilation Refer to the installation instructions for details on
installing the product so it has proper ventilation. The instrument should be
surrounded by the following clearances: 46cm on each side, 117cm on top, 15cm in
front, and 18cm in back.
• Do Not Operate Without Protective Covers Do not operate this instrument with
covers and panels removed.
• Use Proper Fuse Use only the fuse type and rating specified by the manufacturer
for this instrument.
• Avoid Exposed Circuitry Do not touch exposed connections and components
when power is present.
• Avoid Excessive Dust Do not operate in an area with excessive dust.
• Do Not Operate With Suspected Failures If you suspect there is damage to this
instrument, have it inspected by a qualified service person.
• Do Not Operate in Wet/Damp Conditions
• Do Not Operate In An Explosive Atmosphere
• Keep Instrument Surfaces Clean and Dry Solvents such as acetone or thinner will
damage the instrument. Do not use solvents to clean the unit. Avoid abrasive
cleaners; the aerosol shield is liquid-resistant, but easily scratched. Clean the
exterior of the instrument with a soft cloth using plain water. If needed, a mild all-
purpose or nonabrasive cleaner may be used. Use as a disinfectant a 10% solution
of chlorine bleach (5.25% Sodium Hypochlorite) or 70% isopropyl alcohol. Take
special care not to spill liquid inside the instrument.
To Next Page
Loading...