Circutor CVM-A1500 - Page 347

8.1.- DEVICE SOFTWARE UPDATE.
The update les depend on the model of the device:
Table 178:Display software update les.
Model Display software update le
CVM-A1000
rmware_cpu.bin
resources_CVM_A1000.pbr
resources_CVM_A1000_cp.pbr
rmware_embedded.bin
CVM-A1500
rmware_cpu.bin
resources_CVM_A1500.pbr
resources_CVM_A1500_cd.pbr
rmware_embedded.bin
Follow the steps below to update the device software:
1�- Copy the 4 les, Table 178, in the microSD card.
2�- Insert the microSD card in its slot.
3�- Connect the device to the power supply. The device is automatically updated when started.
The updating process may take a few seconds and will be completed once the screen
application has started.
Note: If the expansion modules installed in the device are not compatible with a new software
upgrade, a message will appear on the screen indicating that they need to be upgraded.
Once the device has started, the le “rmware_cpu.bim” is deleted automatically from the
microSD card.
8.2.- UPGRADING THE FIRMWARE OF THE DATALOGGER MODULE
Follow these steps to upgrade the rmware of the Datalogger module:
1�- Access the website used for the internal conguration of the Datalogger module with a
browser.
http://dirección_IP/html/setup�html
Note: The IP address of the Datalogger module can be found in the Expansion modules of the
Information menu (“5.6.3.1.- Datalogger Module”)
2�- In the conguration web site, Figure 405, Information section, click on the Upgrade option.
347
Instruction Manual
CVM-A1000 - CVM-A1500