(Continuation) Standards
Safety requirements for electrical equipment for measurement, control
and laboratory use -- Part 2-030: Particular requirements for testing and
measuring circuits
IEC 61010-2-030:2010
(First Edition)
Safety requirements for electrical equipment for measurement, control,
and laboratory use - Part 1: General requirements
UL 61010-1 3rd edition,
2012-05
Safety Requirements for Electrical Equipment for Measurement, Control
and Laboratory Use - Part 1: General Requirements (Adopted IEC 1010-
1:1990 with modications)
CAN/CSA-C22.2 No. 61010-1,
3rd edition, 2012-05
10.4.- MODBUS TCP (Bridge) COMMUNICATIONS
General features
Maximum power of the module 2 W
Communications : Modbus TCP
Connector RJ-45
Protocol Modbus/TCP
Baud rate Ethernet 10BT / 100BT
Communications: RS-485 gateway
Bus RS-485
Protocol Modbus
Peripheral number 1 ... 255
Baud rate 9600 - 19200 - 38400 - 57600 - 76800 - 115200
Data bits 7- 8
Stop bits 1- 2
Parity No - even - odd
Environmental features
Operating temperature -10ºC ... +50ºC
Storage temperature -20ºC ... +80ºC
Relative humidity (without condensation) 5 ... 95%
Maximum altitude 2000 m
Protection degree
(99)
IP30
Mechanical features
Dimensions (mm) Figure 410
Weight 80 g
Enclosure V0 self-extinguishing plastic
Assembly Panel
(99)
This pollution degree hasn’t been tested by UL.
Standards
Safety requirements for electrical equipment for measurement, control and
laboratory use -- Part 1: General requirements
IEC/EN 61010-1:2010
(Third Edition)
Electromagnetic compatibility (EMC) -- Part 6-2: Generic standards - Immu-
nity for industrial environments
UNE-EN 61000-6-2:2006
Electromagnetic compatibility (EMC) -- Part 6-4: Generic standards - Emis-
sion standard for industrial environments
UNE-EN 61000-6-4:2007
Insulation coordination for equipment within low-voltage systems -- Part 1:
Principles, requirements and tests�
IEC 60664-1:2007
Safety requirements for electrical equipment for measurement, control and
laboratory use -- Part 2-030: Particular requirements for testing and meas-
uring circuits
IEC 61010-2-030:2010
(First Edition)
358
CVM-A1000 - CVM-A1500
Instruction Manual
To Next Page
Loading...
