Cisco 7960 - Composing Messages before Sending

Chapter 5 Configuring Network Settings on the Cisco IP Phone
Configuring Ports
5-28
Cisco IP Phone Administration Guide for Cisco CallManager 3.2, Cisco IP Phones 7960/7940/7910
78-10453-04
Step 6 Use the buttons on the dial pad to enter the selected option.
To enter letters, use the numbers associated with a particular letter. For example,
the 2 key has the letters ABC. For a lower case “a,” press 2 once. Press the 2 key
repeatedly to scroll through the available letters and numbers. Pause after the
selected letter appears on the screen.
Valid values are as follows:
• A (auto negotiate)
• 10H (10basedT/half duplex)
• 10F (10basedT/full duplex)
• 100H (100basedT/half duplex)
• 100F (100basedT/full duplex)
Step 7 Use the << soft key to correct any mistakes.
Step 8 Press the Validate soft key.
Step 9 Press the Save soft key to save this change.
Cisco IP Phone 7910
Procedure
Step 1 Press the Settings button.
Step 2 Press 6 to select Network Configuration.
Step 3 Scroll (using the volume up/down keys) to PC Port Configuration.
Step 4 Press * to enter edit mode.
Step 5 Press the volume down button to scroll down through options.
Options are AUTO, 10HALF, 10FULL, 100HALF, and 100FULL.
Step 6 Select an option, then press the volume up button to exit this menu.
Step 7 Press # to save this change.