CHAPTER
6-1
Cisco IP Phone Administration Guide for Cisco CallManager 3.2, Cisco IP Phones 7960/7940/7910
78-10453-04
6
Configuring Cisco IP Phones, Users,
and Features in Cisco CallManager
After you install Cisco IP Phones in your network, configure their network
settings, and add them to Cisco CallManager, you must then use
Cisco CallManager to configure directory numbers, assign users, and configure
features.
Many of the Cisco IP Phone features available to end users require that you
configure them using the Cisco CallManager Administration application. An
overview of configuration procedures is provided in this chapter; detailed
instructions are available in Cisco CallManager Administration documentation.
This chapter describes setting up user features and providing users with
information about those features. Refer to the following topics:
• Configuring Cisco IP Phones in Cisco CallManager, page 6-2
• Adding Users to Cisco CallManager, page 6-5
• Modifying Phone Button Templates, page 6-5
• Configuring Corporate Directories, page 6-8
• Setting Up User Services, page 6-8
• Providing Information to End Users, page 6-9
To Next Page
Loading...
Need help?
General
