Chapter 4 Adding the Cisco IP Phone 7914 Expansion Module
Installing the 7914 Expansion Module
4-2
Cisco IP Phone Administration Guide for Cisco CallManager 3.2, Cisco IP Phones 7960/7940/7910
78-10453-04
Installing the 7914 Expansion Module
These sections describe how to install the Expansion Module:
• Before You Begin, page 4-2
• Connecting the 7914 Expansion Module, page 4-4
• Start Up Sequence, page 4-14
Before You Begin
Before you begin the installation of the Cisco 7914 Expansion Module, read all
of the following topics in this section:
• Package List, page 4-2
• Footstand Kits, page 4-2
• Additional Equipment, page 4-3
• Safety Notices, page 4-3
Package List
Make sure that you have received all of the following parts in your package:
• One Cisco IP Phone 7914 Expansion Module
• One RS 232 cable
• One Quick Start Guide
• One Warranty Card
Footstand Kits
In addition to the package list items, you will also need a Footstand Kit (separate
orderable item). If you are attaching one 7914 Expansion Module, you need to
have the single Footstand Kit. If you are attaching two 7914 Expansion Modules,
you need to have the double Footstand Kit.
To Next Page
Loading...
Need help?
General
