Cisco 8961 - Page 169

Configuration ReferenceDescriptionFeature
For more information, see “Do Not
Disturb” chapter in the Cisco Unified
Communications Manager Features and
Services Guide.
When DND is turned on, either no audible rings occur
during the ringing-in state of a call, or no audible or
visual notifications of any type occur.
You can configure the phone with a phone-button
template with DND as one of the selected features.
The following DND-related parameters are configurable
in Cisco Unified Communications Manager
Administration:
•
Do Not Disturb: This check box allows you to
enable DND on a per-phone basis. Use the Phone
Configuration window in Cisco Unified
Communications Manager Administration >
Device > Phone.
•
DND Incoming Call Alert: Choose the type of
alert, if any, to play on a phone for incoming calls
when DND is active. This parameter is located on
both the Common Phone Profile window and the
Phone configuration window. The phone
Configuration window value takes precedence.
•
BLF Status Depicts DN: Enables DND status to
override busy/idle state.
Do Not Disturb (DND)
For additional information, see Enable
Video On/Off Setting, on page 193 .
Improves the video conference call flow by removing
the black box that is displayed when one party has the
Auto Transmit setting on their phone set to Off.
Supported on Cisco Unified IP Phones 9951 and 9971.
Not supported on Cisco Unified IP Phone 8961.
Enable Video On/Off
For more information, see EnergyWise
on the Cisco Unified IP Phone Setup, on
page 219.
Enables an IP Phone to sleep (power down) and wake
(power up) at predetermined times, to promote energy
savings
EnergyWise
For more information, see Cisco Unified
Communications Manager Features and
Services Guide.
Improves the Secure Extension Mobility Cross Cluster
(EMCC) feature by preserving the network and security
configurations on the login phone. Doing so maintains
security policies, preserves network bandwidth, and
avoids network failure within the visiting cluster (VC).
Enhanced Secure Extension
Mobility Cross Cluster
No configuration required.The unique call identifier displays at the same font size
as the calling number.
Enlarge Unique Call Identifier
No configuration required.Enables Video, Shared Line, and BLF Speed Dial in
SRST mode.
For more information, see Survivable Remote Site
Telephony, on page 162.
E-SRST Enhancements
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
(SIP)
145
Features, Templates, Services, and User Setup
Telephony features available for Cisco Unified IP Phone
REVIEW DRAFT - CISCO CONFIDENTIAL